Tips about the right way to Substitute a Pull-Down Attic Staircase

On this video, Ask This Earlier Dwelling widespread contractor Tom Silva removes an earlier attic staircase and replaces it with a model new one.

Steps for Altering Attic Stairs:

1. Measure the powerful opening of the attic staircase and match it to find a applicable substitute.
2. Take away the springs from the earlier attic staircase by bending the metal arms forward to launch the stress.
3. Using a reciprocating seen, scale back off the metal hinges of the staircase.
4. Moreover scale back off the nails that preserve the staircase to the development opening.
5. Fastidiously lower the staircase from the opening and take away it.
6. Place the model new staircase into the opening and gently set it down on the trim. Be careful to make sure the trim is able to preserve the staircase. If not, a second particular person might need to hold the staircase in place.
7. Coronary heart the staircase inside the opening using shims.
8. Using a driver, fasten the staircase to the development opening.
9. With the staircase secure, lower the steps halfway to the bottom.
10. Attic staircases have to be scale back to match the height of your non-public house’s ceiling. To do this, use one scrap piece of wood, preserve it tight to 1 side of the staircase until it touches the bottom.
11. Make a mark on the highest closet to the staircase; that is your measurement.
12. Flip the piece of scrap wood clockwise and line it as a lot because the underside in opposition to the second piece of scrap wood. Convey the tip as a lot because the sting and make a mark. That’s the angle.
13. Reduce the angle on the marked piece of scrap wood with a jigsaw.
14. Extend the staircase.
15. Flip the piece of scrap wood so the pointed edge on the bottom is touching the staircase.
16. Match the scale mark on the piece of scrap wood to the joint of the staircase.
17. Mark the scale on the staircase to the underside fringe of the piece of scrap wood.
18. To mark the angle on the staircase, flip the piece of scrap wood so the pointed edge is coping with at an upward angle.
19. Repeat the measuring steps on the second side.
20. Reduce all sides with a reciprocating seen.
21. To place within the attic-stair cowl, place the sheet over the opening.
22. Use staple gun to attach the quilt to the development.

Devices: